D-Link xStack DGS-3200-10 User Manual page 224

xStack
The user may adjust the following parameters to configure a time range on the Switch:
Parameter Description
Range Name Enter a name of no more than 32 alphanumeric characters that will be used to identify this time
range on the Switch. This range name will be used in the Access Profile table to identify the
access profile and associated rule to be enabled during this time range.
Hours This parameter is used to set the time in the day that this time range is to be enabled using the
following parameters:
Use the check boxes to select the corresponding days of the week that this time range is to be
Weekdays
enabled. Tick the Select All Days check box to configure this time range for every day of the week.
Click Apply to implement changes made. Currently configured entries will be displayed in the Time Range Information table in
the bottom half of the window shown above.
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
 Start Time - Use this parameter to identify the starting time of the time range, in hours,
minutes and seconds, based on the 24-hour time system.
 End Time - Use this parameter to identify the ending time of the time range, in hours,
minutes and seconds, based on the 24-hour time system.
211