D-Link xStack DGS-3200-10 User Manual page 204

xStack
Use this to limit RX bandwidth for the profile being configured. This rate is implemented using the
RX Rate (1-15625)
following equation: 1 value = 64kbit/sec. (ex. If the user selects an RX rate of 10 then the ingress
rate is 640kbit/sec.) The user many select a value between 1 and 15625 or tick the No Limit
check box. The default setting is No Limit.
Time Range Tick the check box and enter the name of the Time Range settings that has been previously
Name configured in the Time Range Settings window. This will set specific times when this access rule
will be implemented on the Switch.
Counter Use the drop-down menu to specify if the Counter feature should be Enabled or Disabled. The
Counter feature is used to keep a record of the number of packets that have matched the Access
Rule. For example if you create an Ethernet ACL that permits the source MAC address of 00-00-
00-00-00-01 access to the Switch and a 1000 packets with the source MAC address of 00-00-00-
00-00-01 is received by the Switch, the counter values will be 1000, to indicate that the ACL has
matched 1000 packets.
Ports When a range of ports is to be configured, the Auto Assign check box MUST be ticked in the
Access ID field of this window. If not, the user will be presented with an error message and the
access rule will not be configured. Ticking the All Ports check box will denote all ports on the
Switch.
To view the settings of a p reviously correctly configured rule, click the corresponding Show Details button on the Access Rule
List window to view the following window:
To establish the rule for a previously created Access Profile:
To configure the Access Rules for IPv4, open the Access Profile List window and click Add/View Rules for an IPv4 entry. This
will open the following window:
To remove a previously created rule, click the corresponding Delete Rules button. To add a new Access Rule, click the Add Rule
button:
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6 - 13. Access Rule Detail Information window for Ethernet
Figure 6 - 14. Access Rule List window for IPv4
191