Pvid Auto Assign Settings - D-Link xStack DGS-3200-10 User Manual

xStack
The following fields can be set:
Parameter Description
From Port This drop-down menu allows the selection of the beginning port for a range of ports that will be
included in the Port-based VLAN.
To Port This drop-down menu allows the selection of the ending port for a range of ports that will be
included in the Port-based VLAN.
PVID This field is used to manually assign a PVID to a VLAN. The Switch's default is to assign all ports
to the default VLAN with a VID of 1.The PVID is used by the port to tag outgoing, untagged
packets, and to make filtering decisions about incoming packets. If the port is specified to accept
only tagged frames - as tagging, and an untagged packet is forwarded to the port for transmission,
the port will add an 802.1Q tag using the PVID to write the VID in the tag. When the packet arrives
at its destination, the receiving device will use the PVID to make VLAN forwarding decisions. If the
port receives a packet, and Ingress filtering is Enabled, the port will compare the VID of the
incoming packet to its PVID. If the two are unequal, the port will drop the packet. If the two are
equal, the port will receive the packet.
GVRP The GARP VLAN Registration Protocol (GVRP) enables the port to dynamically become a member
of a VLAN. GVRP is Disabled by default.
Ingress Checking This drop-down menu allows the user to enable the port to compare the VID tag of an incoming
packet with the PVID number assigned to the port. If the two are different, the port filters (drops)
the packet. Disabled disables ingress filtering. Ingress checking is Enabled by default.
Acceptable This field denotes the type of frame that will be accepted by the port. The user may choose
Frame Type between Tagged Only, which means only VLAN tagged frames will be accepted, and All, which
mean both tagged and untagged frames will be accepted. All is enabled by default.

PVID Auto Assign Settings

Users can enable or disable PVID Auto Assign Status. The default setting is enabled.
To view the following window, click L2 Features > PVID Auto Assign Settings:
Click Apply to implement changes made. Please see the previous section for more information about PVIDs.
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 3 - 18. PVID Auto Assign Settings window
79