D-Link xStack DGS-3200-10 User Manual page 100

xStack
Editing the IGMP Snooping parameters for a VLAN:
Click the Edit button next to the VLAN you want to edit.

 The following window appears:
The IGMP Snooping Parameters Settings window is divided into two sections. The following parameters can be viewed/modified
in the top half of the window:
Parameter
VLAN ID
VLAN Name
Query Interval (1-65535 sec)
Max Response Time (1-25
sec)
Robustness Value (1-255)
Last Member Query Interval
(1-25 Sec)
Host Timeout (1-16711450
sec)
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 3 - 26. IGMP Snooping Parameters Settings window
Description
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN the user
wishes to modify the IGMP Snooping Settings for.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN the user
wishes to modify the IGMP Snooping Settings for.
This parameter specifies the length of time between sending IGMP Queries.
Default= 125.
This parameter is used to set the maximum amount of time allowed before sending
an IGMP response report. Default= 10.
This parameter is used as a tuning variable that allows for a large number of packets
being lost on subnetworks. Specify a value between 1 and 255. Specify a high value
if you expect your subnetworks to lose a large number of packets. Default= 2.
This parameter is used to set the maximum amount of time between group-specific
query messages, including messages that have been sent in response to leave
group messages. Default= 2.
This is the maximum amount of time in seconds allowed for a host to continue
membership in a multicast group without the Switch receiving a host membership
report. Default = 260.
87