Mac Address Aging Time; Web Settings - D-Link xStack DGS-3200-10 User Manual

xStack

MAC Address Aging Time

Users can configure the MAC Address aging time on the Switch.
To view the following window, click Configuration > MAC Address Aging Time:
Enter a value between 10 and 875 seconds.
The following parameter may be configured or viewed:
Parameter Description
MAC Address This field specifies the length of time a learned MAC Address will remain in the forwarding table
Aging Time (10- without being accessed (that is, how long a learned MAC Address is allowed to remain idle). To
875) change this, type in a different value to represent the MAC address age-out time in seconds.
The MAC Address Aging Time can be set to any value between 10 and 875 seconds. The
default setting is 300 seconds.
Click Apply to set the MAC Address Aging Time.

Web Settings

Users can configure the Web settings on the Switch.
To view the following window, click Configuration > Web Settings:
The following parameters may be configured or viewed:
Parameter Description
Web Status Web-based management is Enabled by default. If you choose to disable this by clicking
Disabled, you will lose the ability to configure the system through the web interface as soon as
these settings are applied.
Port (1-65535) The TCP port number used for Web-based management of the Switch. The "well-known" TCP
port for the Web protocol is 80.
Click Apply to set the web settings.
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 2 – 23. MAC Address Aging Time window
Figure 2 – 24. Web Settings window
26