Omron ZFX-C10 User Manual page 80

Image adjustment (if necessary)
The following items can be changed and set to the image of the measurement target.
MENU mode - [Setup] - [Item] - [Img Adj]
Item
Color filter
Filtering
BGS level
Detailed settings (if necessary)
When measurement is not stable, adjust the detailed conditions.
MENU mode - [Setup] - [Item] - [Detail]
Setup Item
Detection size
Detection interval
Noise level
Calibration
Coordinates mode
Coordinates mode p.63
78
Setting Measurement Items
Description
For details, see "Image Adjustment". p.80
Setting value Description
4 to 64 (default value: 8) Creates a small detection area corresponding to the detection
size inside the measurement region.
4 to 64 (default value: 8)
The average density is calculated for each detection area. The
average density of the detection area is then compared with the
surrounding average density, and the defect position is
detected by how much the average density differs with the sur-
rounding area. The difference with the average density that
was the largest is output as the defect value.
0 to 255 Places having a defect value lower than the noise level are
(default value: 60) removed as the noise component, while places having a defect
value higher than the noise level are counted as defect posi-
tions.
OFF (default value) Measurement results are output using the camera's coordinate
values.
ON Measurement results are output using the coordinate value
converted by the calibration function.
Normal (default value) The position information of the input image coordinate system
itself is output.
Pos. correction When position shift correction is set, the position information is
output using the coordinate system corrected to the original
state when the coordinate system was registered.
Detection interval Detection area corresponding
to detection size
ZFX-C User's Manual