System Settings; Serial Communication; Camera Specifications; Communication Setup - Omron ZFX-C10 User Manual

System Settings

Camera Specifications

Set the basic conditions of the camera connected to the Controller.
MENU mode - [System] - [Camera]
Setup Item
White balance
Strobe delay time
Strobe polarity
Strobe width

Communication Setup

Set the communication specifications for the Controller matched to the communication specifications of
external devices.

Serial Communication

RS-232C/422
Set the basic communication specifications for when communications is performed with external devices on
the serial interface. Set the communication specifications to match those of the external devices.
MENU mode - [System] - [Comm] - [RS-232C/422]
Setup Item
Interface
Baud rate
Data length
Parity
Stop bits
112

System Settings

Description
The environment or lighting around the camera sometimes makes images captured from the
camera look as if they are color-tinted even if the image is of a white measurement target.
The function for correcting the color so that white objects are reproduced correctly in white
on screen is called "white balance."
Automatically adjusts the white balance while displaying white paper or cloth on screen.
This function can be set only when a color camera is connected to the Controller.
Set the delay time from input of the TRIG signal up to output of the STGOUT signal.
Range: 0 to 60000 µs
Sets the output polarity of the STGOUT signal.
Range: Positive/Negative
<Positive when signal is in PNP type>
<Negative when signal is in NPN type>
High
Low
When strobe polarity is set to "Negative", a delay of about 50 to 100µs occurs from input
of the TRIG signal until the STGOUT signal turns Low. When a high-speed shutter is
used, use the Controller with the strobe polarity set to "Positive".
Sets the time that the STGOUT signal is output.
Range: 0 to 60000 µs
Setting value
RS-232C (default value), RS-422
9600, 19200, 38400 (default value), 57600, 115200
7 bit, 8 bits (default value)
None (default value), Even, Odd
1 bit (default value), 2 bits
<Negative when signal is in PNP type>
<Positive when signal is in NPN type>
High
Low
ZFX-C User's Manual