How To Connect With Cx-Programmer - Omron WS02-SIMC1-E - V1.9 REV 12-2009 Operation Manual

Connecting to the CX-Programmer Version 2.1 or Lower

3-8-2 How to Connect with CX-Programmer

Disconnect
•
Guide to Connect
•
Close
•
Note Correct the Node address of FinsGateway Communications Unit only if it
overlaps with the node address of the Network Communications Unit when
connecting to the CX-Simulator.
This section explains how to connect the CX-Simulator with the
CX-Programmer.
1,2,3... 1. Start the CX-Simulator and select a PLC data folder needed for debugging
application programs. The windows for [Work CX-Simulator],
[CX-Simulator Debug Console], and [System Status Setting] are displayed.
2. Press the [Connect] button in the [Work CX-Simulator] window. The FINS
Address to be set to the CX-Programmer will be displayed in the Guide to
Connect.
Exit the FinsGateway Communications Unit
started when connecting to the CX-Simulator
and return to the status before the startup.
Disconnecting the CX-Simulator will bring the
CX-Simulator to the following.
The FinsGateway Communications Unit
•
stops.
Restore the routing table of FinsGateway to
•
the original status.
The Serial Communications Server stops.
•
The mode will be in PROGRAM if the Ladder
•
Engine is running.
Display the settings for connecting with the
CX-Simulator.
Exit the window with the present settings.
Section 3-8
FINS address to be
set to the
CX-Programmer
73