Omron WS02-SIMC1-E - V1.9 REV 12-2009 Operation Manual page 252

I/O Memory Allocation
Address
Words Bits
A299 All Program
Address
Where
Program
Stopped
(Leftmost 4
digits)
A300 All Error Log
Pointer
A301 All Current EM
Bank
A302 A30200 CS/CJ-seri
to es CPU
A30215 Bus Unit
Initializing
Flags
Name
(A294 contains the task number
of the task where program exe-
cution was stopped.)
When an error occurs, the Error
Log Pointer is incremented by 1
to indicate the location where the
next error record will be recorded
as an offset from the beginning of
the Error Log Area (A100 to
A199).
The Error Log Pointer can be
cleared to 00 by turning A50014
(the Error Log Reset Bit) from
OFF to ON.
When the Error Log Pointer has
reached 14 (20 decimal), the next
record is stored in A195 to A199
when the next error occurs.
This word contains the current
EM bank number in 4-digit
hexadecimal. The current bank
number can be changed with the
EMBC(281) instruction.
These flags are ON while the
corresponding CS/CJ-series
CPU Bus Unit is initializing after
its CS/CJ-series CPU Bus Unit
Restart Bit (A50100 to A50115) is
turned from OFF to ON or the
power is turned ON.
Bits 00 to 15 correspond to unit
numbers 0 to 15.
CS/CJ-series PLC
Function
CX-Simulator
Settings Function
Left 4 digits Same as
of the pro- CS/CJ-series
gram ad- PLC.
dress
00 to 14 Same as
hexadeci- CS/CJ-series
mal PLC.
0000 to Same as
000C CS/CJ-series
hexadeci- PLC.
mal
0: Not ini- Not used.
tializing
1: Initializ-
ing
(Reset to 0
automati-
cally after
initializa-
tion.)
Section 9-3
Settings
213