Omron WS02-SIMC1-E - V1.9 REV 12-2009 Operation Manual page 272

I/O Memory Allocation
Address
Words Bits
A512 to Power In-
A513 terruption
Time
A514 Number of
Power In-
terruptions
A523 Total Power
ON Time
A526 A52600 RS-232C
Port Restart
Bit
A52601 Peripheral
Port Restart
Bit
A52614 SYSMAC
BUS Mas-
ter 1 Re-
start Bit
A52615 SYSMAC
BUS Mas-
ter 0 Re-
start Bit
Name
These words contain the time at
which the power was interrupted.
The contents are updated every
time that the power is interrupted.
The data is stored in BCD.
A51200 to A51207:
Second (00 to 59)
A51208 to A51215:
Minute (00 to 59)
A51300 to A51307:
Hour (00 to 23)
A51308 to A51315:
Day of month (01 to 31)
(These words are not cleared at
start-up.)
Contains the number of times that
power has been interrupted since
the power was first turned ON.
The data is stored in binary. To
reset this value, overwrite the
current value with 0000.
(This word is not cleared at
start-up, but it is cleared when the
Memory Corruption Detected
Flag (A39511) goes ON.)
Contains the total time that the
PLC has been on in 10-hour
units. The data is stored in binary
and it is updated every 10 hours.
To reset this value, overwrite the
current value with 0000.
Turn this bit ON to restart the
RS-232C port. (Do not use this bit
when the port is operating in
peripheral bus mode.)
This bit is turned OFF automati-
cally when the restart processing
is completed.
Turn this bit ON to restart the
peripheral port.
Turn this bit ON to restart
SYSMAC BUS Remote I/O Mas-
ter Unit 1.
This bit is turned OFF automati-
cally when the restart processing
is completed.
Turn this bit ON to restart
SYSMAC BUS Remote I/O Mas-
ter Unit 0.
This bit is turned OFF automati-
cally when the restart processing
is completed.
CS/CJ-series PLC
Function
CX-Simulator
Settings Function
See Func- Same as
tion col- CS/CJ-series
umn. PLC.
0000 to Same as
FFFF CS/CJ-series
hexadeci- PLC.
mal
0000 to Not used.
FFFF
hexadeci-
mal
0 to 1: Re- Not used.
start
0 to 1: Re- Not used.
start
0 to 1: Re- Not used.
start
0 to 1: Re- Not used.
start
Section 9-3
Settings
233