Alarms And Remedies - Omron WS02-SIMC1-E - V1.9 REV 12-2009 Operation Manual

Alarms and Remedies

10-2 Alarms and Remedies

Alarms
A fatal error occurred on
CX-Simulator Ladder Engine. Re-
start Debugger. catch runtime error
What: --
An attempt was made to operate a
FINS that was not for CPU Unit.
Command log finished because the
size of log file exceeds maximum.
CX-Simulator Communications Unit:
Sending buffer overflow. FINS mes-
sages were lost.
CX-Simulator Ladder Engine ter-
minated by an error. Restart De-
bugger.
Cycle time over. CX-Simulator
Ladder Engine stop.
Failed to auto boot the data file.
Autoexec.iom is invalid.
Failed to create a command log file. The specified file is
Failed to create a folder for the card
files.
Failed to create a folder for the EM
files.
Failed to create a header of FINS
response (Fin-
sHead_composeResponse). Check
the data of received header.
Failed to create a header of FINS
response. Check the data of re-
ceived header.
Failed to create the memory pres-
ervation file.
Failed to send a FINS command
(Fins_sendData). Check the target
FINS address.
Failed to send a FINS command.
Check the target FINS address.
The following table shows possible alarms and their remedies when executing
the CX-Simulator. Remove the alarm causes referring to the remedies.
Causes
Windows system call
error.
Wrong destination
address of the FINS
command.
Heavy-traffic FINS
communications.
Failed to read Auto-
exec.iom.
read-only or the disk
space is short.
The PLC data folder is
read-only, etc.
The PLC data folder is
read-only, etc.
Wrong destination
address of the FINS
command.
Wrong destination
address of the FINS
command.
Failed to create the
file in the PLC data
folder.
Heavy-traffic FINS
communications or
wrong destination of
the FINS command.
Wrong destination of
the FINS command or
Heavy-traffic FINS
communications.
Exit some application programs and try again.
Set "0" to the FINS unit address for the destination of the
application that sent the FINS command.
Create a new command log file.
Lower the frequency of FINS command send from the
Ladder Engine or the application program.
1. Exit the CX-Simulator.
2. Delete all erroneous Memory?.dat files in the PLC data
folder.
Correct the ladder program or change the setting of the
WDT.
Check for Autoexec.iom in the Card folder (CF folder).
Increase the disk space or change the destination for cre-
ating the log file.
Delete the PLC data folder and all files/folders in it and
create a new PLC again.
Delete the PLC data folder and all files/folders in it and
create a new PLC again.
Check the destination of the FINS command sent by the
Ladder Engine or application program or settings of the
routing table.
Check the destination of the FINS command sent by the
Ladder Engine or application program or settings of the
routing table.
1. Check for enough disk space (10 MB) in the PLC data
folder.
2. Check if the PLC data folder is write-enabled or the user
is authorized to write.
1. Lower the frequency of FINS command send from the
Ladder Engine or application program.
2. Check the destination of the FINS command sent by the
Ladder Engine or the application program or settings of
the routing table.
1. Check the destination of the FINS command sent by the
Ladder Engine or the application program or settings of
the routing table.
2. Lower the frequency of FINS command send from the
Ladder Engine or the application program.
Section 10-2
Remedies
245