Omron WS02-SIMC1-E - V1.9 REV 12-2009 Operation Manual page 114

Connecting to the CX-Programmer Version 2.1 or Lower
5. Change the settings of [Network] and [Node] for [FINS Destination Ad-
dress] to the network address and the node address for the FINS address
displayed in the Guide to Connect.
The routing table for FinsGateway must be changed if the Network address
•
is to be changed.
Note 1. Do not change the unit address for the FinsGateway Communications Unit
with FinsGateway setting tool, etc. Changing the unit address may cause
the [Connect] operation to fail.
2. Do not set items to the local network table when setting the routing table to
the CX-Simulator. The local network table will automatically be changed
when [Connect] is executed. If communications with the Ladder Engine
can not be executed after setting the routing table, [Disconnect] and then
[Connect] again.
3. If a new FinsGateway Communications Unit with the same name is started
by the FinsGateway service manager, etc. during [Connect], the new unit
will fail to start. The Communications Unit with the same name can not be
used simultaneously.
4. For instructions on changing the routing tables, refer to Section 3 of the
CX-Integrator Operation Manual (W445).
Section 3-8
75