Omron WS02-SIMC1-E - V1.9 REV 12-2009 Operation Manual page 241

I/O Memory Allocation
Item
Periph- Communi-
eral Port cations rate
Settings (bps)
CPU Unit's
Unit Num-
ber in Host
Link Mode
Maximum
Unit Num-
ber in NT
Link Mode
RS-232C RS-232C
Port Port Set-
Set-tings tings Selec-
tion
Communi-
cations
mode
Data bits
Stop bits
Parity
202
CS/CJ-series PLC
Settings
00: 9,600 Settings 00 and 06 through 0A
01: 300 are valid when the communica-
02: 600 tions mode is set to peripheral
03: 1,200 bus.
04: 2,400 This setting is not valid when the
05: 4,800 communications mode is set to
06: 9,600 NT Link.
07: 19,200
08: 38,400
09: 57,600
0A: 115,200
Default: 00
00 to 1F This setting determines the CPU
(0 to 31) Unit's unit number when it is
connected in a 1-to-N (N=2 to 32)
Default: 00 host link.
0 to 7 This setting determines the high-
est unit number of PT that can be
Default: 0 connected to the PLC in NT Link
mode.
0: Default* This setting is effective only when
1: PLC Setup pin 5 of the DIP switch on the
front of the CPU Unit is OFF.
Default: 0 *The default settings are: host
link mode, 1 start bit, 7 data bits,
even parity, 2 stop bits, and a
baud rate of 9,600 bps.
00: Host link This setting determines whether
02: NT link the RS-232C port will operate in
(1: N mode) host link mode or another serial
03: No-protocol communications mode. (Host link
04: Peripheral can be specified with 00 or
bus 05.)The Peripheral bus mode is
05: Host link for communications with Pro-
gramming Devices other than the
Default: 0 Programming Console.
0: 7 bits These settings are valid only
1: 8 bits when the communications mode
is set to host link or no-protocol.
Default: 0 These settings are also valid only
when the RS-232C Port Settings
0: 2 bits
Selection is set to 1: PLC Setup.
1: 1 bit
Default: 0
00: Even
01: Odd
10: None
Default: 00
Function
Section 9-3
CX-Simulator
Settings Function
Not used.
Not used.
Same as When
CS/CJ-series No-protocol is
PLC. set, the
RS-232C
Send Ready
Flag (A39205)
turns ON.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.