Dip Switch Settings - Omron NT11 - 01-2004 User Manual

Description of Parts and Settings
2-1-2

DIP Switch Settings

DIP Switch Settings
!Caution In addition to the DIP switches, set also the "Comm. Method", "Host Link
!Caution After changing the switch settings, always press the reset switch or turn the
!Caution Confirm system safety before turning the power ON/OFF or resetting.
Correct Use
18
Set the NT11 operation status with the DIP switches located in the bottom
right corner on the rear side of the body.
DIP Switch Pin
SW1 1
0
SW2 1
0
SW3 1
0
SW4 1
0
SW5 Reserved.
SW6 1
0
Emergency transfer mode: When power to the NT11 is turned ON with DIP
Speed", "Automatic Reset", etc. at the memory switches. For these settings,
refer to 3-7 Setting the Conditions of Communications with the PLC by Using
the Memory Switches (page 71).
power off and back on.
Otherwise the system will not operate as expected.
Otherwise the system may operate unpredictably.
Use the "System program erase" function only when changing the system
program.
It the system program is erased, it will not be possible to use the functions of
the NT11 unless another system program is transferred.
Function
RS-422A terminating resistance used
Not used
Screen data forced initialize effective
Ineffective
Emergency transfer mode
Ineffective
Switching to the System Menu disabled
Enabled
System program erase enabled
Disabled
switch pin 3 turned ON, data transfer mode will be
entered directly without any other operation.
Section 2-1
Factory setting: ALL OFF