Omron NT11 - 01-2004 User Manual page 83

Registering the Screen Data
Transmitting the Screen Data from the Support Tool
Reference
Operation
70
To transmit the screen data from the support tool to the NT11, connect the
NT11 to the computer on which the support tool is being used, and follow the
procedure below.
The NT11 uses one connector for the connection to both a PLC and a com-
puter. If it has been connected to a PLC, disconnect the PLC and connect the
support tool (computer) to the NT11, and then, transmit the screen data.
1. Connect the NT11 to the computer on which the support tool is being used,
and turn ON the NT11.
2. Turn ON the computer and start up the support tool.
3. Enter the "Transmit Mode" by operating the menu of the NT11 as men-
tioned below.
[System Menu]
Quit
Transmit Mode
Maintenance Mode
[Transmit Mode]
4. Specify downloading screen data from the NTST or Transfer Utility. (With
the NTST, select "connect - Download - Application.")
5. The NT11 will display the following screen when the screen data is being
transmitted.
[Transmit Mode]
Tool→NT11
(Screen Data)
6. When the screen data transmission is completed, the support tool will dis-
play the following screen.
7. Press any key on the support tool to return to the File Selection screen.
1.0 Select "Transmit Mode" with
the key, then press
"ENTER".
0KB
Section 3-6