Omron NT11 - 01-2004 User Manual page 76

Operation Modes and the System Menu
Basic key operations in the maintenance mode
Selecting the Menu Items
System Menu Items
Switching from the System Menu to the RUN mode
Operation
Any two function keys
[ENTER] key
Arrow keys
Note that on the screen for confirming erasure of the system program, the
"Cancel" and "Set/execute" keys are displayed in reverse video in order to pre-
vent mistaken deletion of the program.
Press the or key on the panel of the NT11 to move the highlighting up
or down. When the required item is highlighted, press the "ENTER" key to
select it.
Menu items allow to make the ON/OFF selection or to call subsequent menu
or screen.
Example 1
To call the "Maintenance Mode Menu" by selecting the "Maintenance Mode"
on the System Menu screen:
[System Menu]
Quit
Transmit Mode
Maintenance Mode
PT Setting
I/O Check
Initialize Memory
Memory Switch
The System Menu items and their functions are given below.
Menu Item
Quit The System Menu screen is cleared and the NT11 will return to the
RUN mode.
Transmit The Transmit Mode screen will be displayed to allow the transmission
Mode of the screen data between the NT11 and the support tool. For the
transmission of the screen data, refer to 3-6 Registering the Screen
Data (page 69).
Maintenance The Maintenance Mode menu will be displayed to allow the mainte-
Mode nance of the NT11 system.
The NT11 will exit the System Menu and switch to the RUN mode in the cases
mentioned below.
• Selecting "Quit" in the System Menu.
• The screen (System keys) is not pressed for over 10 seconds.
Function
Cancel
Set/execute
Cursor motion
1.0
Select "Maintenance
Mode" with the
then press "ENTER".
Function
Section 3-3
key,
63