Screen Creation Procedure - Omron NT11 - 01-2004 User Manual

Screen Creation Procedure

5-1

Screen Creation Procedure

Creating a New Screen
Tool Setting (PT model)
Set the PT model as follows:
NT11: Set NT11-V1.
NT21: Set NT21.
NT31: Set NT31-V2.
NT31C: Set NT31C-V2.
NT631: Set NT631-V2.
NT631C: Set NT631C-V2.
System Setting (Memory Switch Setting)
Set the memory switches that determine the
basic operation of the PT.
The numeral/character string/bit memory table
entry settings should also be made at this
stage.
Setting for PT Status Control/Notify Area
Allocate words for the PT status control area
and PT status notify area, necessary for the
direct connection function, in the host.
For details, refer to 4-3 Areas for Control/
Notification (page 89).
108
Follow the procedure shown below to create screens for the NT11.
The following gives the procedure assuming that the setting for the PT has
been completed. The operating procedure for a Support Tool is not given
here. For the operating procedure for the Support Tool, refer to the NT-series
Support Tool Version 4.7 for Windows Operation Manual (V061-E1-@).
Correcting an Existing File
File Designation
Designate a work file.
NT-series Support Tool
Section 5-1
Importing DOS Version Data
File Designation
Designate the work file to be data converted.
NT-series Support Tool