Omron NT11 - 01-2004 User Manual page 47

Connection to a PLC by the Host Link (RS-232C Type)
34
Port connecting to PT
RS-232C port (D-Sub 9-pin) of CPM2C-CN111
Peripheral port of CPM2C-CN111
RS-232C port (D-Sub 9-pin) of CS1W-CN118
Peripheral port of CS1W-CN114
Peripheral port
CPM2C-CN111
CPM2C
RS-232C port
(D-Sub 9-pin, female)
Setting the DIP Switches of a C200HX/HG/HE(-Z)E, CQM1, or CQM1H
When using a C200HX/HG/HE(-Z)E, CQM1, or CQM1H, the DIP switches on
the front panel must be set as shown below in order to make the settings in
the PLC Setup (in the DM Area) effective.
C200HX/HG/HE(-Z)E
RS-232C port communication condition setting
Set pin 5 to OFF to make the settings made in
PLC Setup effective.
When using the CQM1H's built-in peripheral port, turn ON SW7.
Setting the Switches of a CPM2A
When using a CPM2A, the switches on the front panel must be set as shown
below in order to make the PLC Setup settings effective.
Setting the Switches of a CPM2C
When using a CPM2C, the switches on the front panel must be set as shown
below in order to make the PLC Setup settings effective.
Built-in RS-232C port settings
Peripheral port settings
Built-in RS-232C port settings
Peripheral port settings
CS1W-CN118 CPM2C
RS-232C port
(D-Sub 9-pin, female)
CQM1 CQM1H
Set the Communications
switch to OFF (down
position).
Section 2-4
PLC Setup
CPM2C
CS1W-CN114
Peripheral port