Initializing Memory; Initialization Of The Screen Data - Omron NT11 - 01-2004 User Manual

Initializing Memory

3-4

Initializing Memory

Reference
Note
3-4-1

Initialization of the Screen Data

Initialization by using the System Menu
64
If the NT11 is used for the first time or if the screen data is ruined and the
NT11 cannot be normally started, the memory needs to be initialized.
The memory initialization is required in the cases mentioned below.
• When the NT11 is used for the first time or when an error message indi-
cating that the screen data is ruined etc. when the NT11 is started.
• When the screen has disappeared during the start-up or operation.
Use the NT11 DIP SW2-2 "Screen data forced initialize effective/ineffective";
initializes the memory.
When an error has occurred, the error messages such as "Screen data cor-
rupted" will be displayed. For the error messages displayed on the screen,
refer to 6-2 Responding to Displayed Error Messages (page 138).
Initializing the screen data memory will erase entire screen data registered in
the NT11. Make sure that there are backup copies of the screen data on
floppy disks before starting the initialization.
The screen data can be initialized by either of the following two methods.
• Initialization by using the System Menu
• Initialization by using the DIP switch
Initialize the image data memory by following the procedure given below.
[System Menu]
Quit
Transmit Mode
Maintenance Mode
PT Setting
I/O Check
Initialize Memory
Memory Switch
Section 3-4
Select "Maintenance
Mode" with the key,
then press "ENTER".
Select "Initialize Memory"
with the key, then press
"ENTER".