Communications Settings - Omron F150-3 - MANUAL 2 Operation Manual

Communications Settings

Nonmeasurement Commands
F150
Execute command
Output result
Note When RC/CS or Xon/off flow control is selected, if a
8-1-2 Communications Settings
Baud Rate and Communications Mode
200
The following timing chart shows the basic flow of command
execution.
response is not received from the computer within a set
time, the F150 will conclude that there is a disconnection
or that the computer is not operating normally, and will
generate a timeout error. An error message will be dis-
played and the error terminal will turn ON.
The following explains how to set the baud rate, data length,
and other communications specifications.
The same communications settings must be used for both the
F150 and the external device.
Computer
Input command
*The BUSY terminal is ON while the
commands are being executed.
Receive result
Section 8-1