Version Information - Omron F150-3 - MANUAL 2 Operation Manual

This appendix gives details of the functions that have been added as a result of
software upgrading and provides information about data compatibility with previ-
ous versions of the software.
Data Compatibility
Scene Data
• Ver. 1.@@ (F150-C10E) data cannot be used with this version.
• Ver. 2.@@ (F150-C10E-2, F150-C15E-2, F150-C10E-2-DRT) data can be
used with this version.
System Data
• Ver. 1.@@ (F150-C10E) data cannot be used with this version.
• Ver. 2.@@ (F150-C10E-2, F150-C15E-2, F150-C10E-2-DRT) data can be
used with this version.
Functions (Ver. 2.1@ to Ver. 3.0@)
Two Cameras with One Controller
With this version, by connecting a Two-camera Unit (F150-A20), two Cameras
can be operated from just one Controller, and two images can be taken simulta-
neously. The default menu configuration is for operation with one Camera and so
before using two Cameras, it is necessary to change the menu configuration.
→ Page 29
Light Control Menu
With this version, a menu for controlling light level has been added under Set/
Adjust. When an Intelligent Light Source (F150-LTC20/LTC50) is used, this
menu allows the light level to be controlled from the F150. RS-232C and Compo-
Bus/D commands have been added that allow the light level to be controlled in
this way from external devices. → Page 41, 59
Density Averaging and Relative Search
Two more measurement methods, density averaging and relative search, have
been added with this version. → Page 10, 108, 112
Noise Level Added to Edge Detection Conditions
It is now possible to set a noise level that determines the existence of edges and
so erroneous edge detection is reduced. → Page 93
Appendix A

Version Information

331