Timing Charts; Basic Mode - Omron F150-3 - MANUAL 2 Operation Manual

Timing Charts

10-4

Timing Charts

10-4-1

Basic Mode

One Measurement
Word +0, bit 8
Output area
One Measurement
Word +2, bit 12
One Measurement
Completed Flag
Word +0, bit 2
Word +0, bit 4
Input area
Word +1, all bits
Judgement output
Word +0, bit 8
Word +3 to +26
Word +0, bit 9
Note There is no expand command response output and the
The meanings of the arrows and dotted lines used in this sec-
tion are as follows:
The F150 is controlled automatically according to the
status of the bit at the base of the arrow.
Perform ON/OFF control according to the status of
the bit at the base of the arrow.
Dotted lines indicate optional output. By deselecting
outputs, the number of bytes can be reduced.
Data output
words allocated for this output will always be 0. The set-
ting for response output in the Communications Specifica-
tions Screen should be turned OFF before inputting a
command.
Section 10-4
Measurement
309