Communications Settings; Ethernet/Ip Connection Parameters; Io-Link Connection Parameter; Slave Terminal Configuration - Omron CJ2-CPU Connection Manual

6. Communications Settings

This section describes the contents of the parameter and tag data link settings that are all
defined in this document.

6.1. EtherNet/IP Connection Parameters

The parameters required for connecting PLC to Slave Terminal via EtherNet/IP are shown
below.
<PLC and Slave Terminal Settings>
Item
IP address
Subnet mask
Network interface setting

6.2. IO-Link Connection Parameter

The parameter required for connecting IO-Link Master Unit and Photoelectric Sensor via
IO-Link is shown below.
In this document, Photoelectric Sensor is connected to Port 1 on IO-Link Master Unit.
<IO-Link Master Unit Setting>
Port1 IO-Link Device Configuration Data / Master Control

6.3. Slave Terminal Configuration

The Slave Terminal configuration is shown below.
<Slave Terminal Configuration and Device Names>
NX Unit number
0 1
PLC (Node 1)
192.168.250.1
255.255.255.0
-
Item
Name
0 EtherNet/IP Coupler Unit
1 IO-Link Master Unit
6．Communications Settings
Slave Terminal (Node 2)
192.168.250.2
255.255.255.0
Enable Tag Data Links
Set value
IO-Link Mode (Default)
Model
NX-EIC202
NX-ILM400
9