Relative Search - Omron F150-3 - MANUAL 2 Operation Manual

Drawing Measurement Regions and Setting Evaluation Criteria Section 3-4
Correct
Clear
2 Setting the Evaluation Criteria
Scn 0 = SET = 0. Density avg
Region
Conditions
Density avg:
[0.000: 255.000]
Procedure
3-4-8

Relative Search

112
2
The selections Correct and Clear will be displayed. Select
the desired operation.
If Correct is selected, the screen for selecting the
region number will be displayed. Correct the size
and position of the figure as desired.
If Clear is selected, the selected figure will be cleared.
Set the range of the average density for an OK judgement.
End
1
Select Conditions.
Region
Conditions
2
Set the items.
Refer to the following page for details on inputting values:
→ Page 26
3
Select End to enter the settings.
Use this method to obtain the positions of markings, holes,
and other features, and to judge whether these features are
within the acceptable range. This method is based on relative
position so models must be registered in two positions: the
measurement position and the standard position.
Average density range
for an OK judgement
1