Litpara: Light Parameter - Omron F150-3 - MANUAL 2 Operation Manual

Input Commands
Output
Example
8-4-7

LITPARA: Light Parameter

Reading Light Level of Intelligent Light Source
Input
Output
Section A
Section B
Section C
• Specify a memory image number in the range 0 to 23.
The image data is saved with Xmodem (-CRC or -SUM)
protocol.
• The memory image is transferred in BMP format.
• When preparations to send the data are completed, the
F150 will send the character string "READY" to the exter-
nal device. Start the data transfer at the external device
when the "READY" string has been received.
Data correctly saved:
Data not correctly saved:
Input:
IMGSAVE 2
The data in memory image 2 is saved to the external de-
vice.
Output:
OK
LITPARA is used to read or change the light level of the Intelli-
gent Light Source.
LITPARA
<Camera_number>
Specify either 0 or 1 as the Camera number. If the 2-Camera
Unit is not used, specify 0.
The light level is output as either a 5 or 8-digit number. Each
digit represents the level for one illuminated region in the
range 0 to 7 (0 = not lit).
• F150-LTC20
Section E
Section D
• F150-LTC50
Section 8-4
OK
ER
As seen from the Camera
211