Devicenet Start-Up - Omron CX-ONE - INTRODUCTION GUIDE 1 Introduction Manual

PLC Network
PLC
Start-Up
Start-Up
Re-connect to a PLC
with CX-Integrator
Move the cursor on the
PLC and right-click
Select
[Start Routing Table]
Right-click and select local
network (Unit) [Insert CPU
SIOU] or local network (port)
[Insert PORT]
Enter its local network
number, then click [OK]
Reconnecting CX-Integrator
DeviceNet NT Link
Start-Up Start-Up
Confirming the Routing Table is not Configured
Confirming the Routing Table is not Configured
(1) Check that Routing Table is not configured.
(2) Configure the Routing Table.
(3) Edit the Routing Table and transfer to [PLC].
Set the Routing Table as shown below:
• Assign a network number to a Unit number.
• A Unit number can be checked on the online information window.
• Assign a network number to each network.
The Controller Link network number is same for other PLCs.
(4) Check if the error is solved.
• Re-connect to the PLC.
• All errors should be solved and no error messages should be displayed.
• The network number is displayed on the communications Unit.
Controller
CompoWay
Link
/F Start-Up
Start-Up
Saving Equipment
System Disass'y /
Config. Reass'y
Check Routing Table
Check Routing Table
presence. If the Routing Table
presence. If the Routing Table
is not configured, create one.
is not configured, create one.
System Controller
Config. Link
Verification Diagnosis