Omron CX-ONE - INTRODUCTION GUIDE 1 Introduction Manual page 55

各種PLC
PLC Network
ネットワーク PLC
Start-Up
Start-Up
の立ち上げ
Select [Change
connection to this PLC]
Select [Connect]
Select
[Transfer [Network to PC]]
Select [Save As...]
DeviceNet NT Link
Start-Up Start-Up
Saving System Configuration (2)
Saving System Configuration (2)
(5) Connect to a PLC on the Controller Link network.
Select a remote PLC on the Controller Link network configuration screen (a PLC without a
square symbol) to switch the connection destination to the PLC.
Destination PLC communication device configuration is displayed in the online connection
information window.
All communications Units and
All communications Units and
ports are also displayed in the
ports are also displayed in the
online connection information
online connection information
window.
window.
(6) Send the DeviceNet network configuration on the remote PLC.
Connect to DeviceNet from the online connection information window and send the
network configuration to the personal computer.
(7) Send the DeviceNet network configuration on another remote PLC.
Repeat the steps from (6) and (7). After transmission, all the networks sent to the
workspace are displayed.
(8) Save all the configurations.
Controller
CompoWay
Link
/F Start-Up
Start-Up
Saving Equipment
System Disass'y /
Config. Reass'y
A Green frame is displayed on
A Green frame is displayed on
the specified remote PLC.
the specified remote PLC.
System Controller
Config. Link
Verification Diagnosis