Omron CX-ONE - INTRODUCTION GUIDE 1 Introduction Manual page 47

各種PLC
PLC Network
ネットワーク PLC
Start-Up
Start-Up
の立ち上げ
Right-click a CPU Unit
under a connection target
PLC in the online
connection information
window, then select
[Connect]
DeviceNet NT Link
Start-Up Start-Up
NT Link Start-Up
NT Link Start-Up
Remove NT Link communication errors and establish communications.
Remove NT Link communication errors and establish communications.
⇒ Release NS Connecting . . . message.
⇒ Release NS Connecting . . . message.
⇒ Check NS configuration through CX-Integrator.
⇒ Check NS configuration through CX-Integrator.
(1) Connect to PLC online, then connect to a CPU Unit through the online connection
information window.
(2) Select in the order from upper link port to NT link.
(3) Next, select [NT Link Tool] > [NTLink Auto Online Setting] from the CPU Unit.
Automatic NT Link connection function is used to automatically connect NS series PT
and PLC via serial connection (NT Link). Connection is automatically performed by
overwriting the PLC serial communication port settings by adjusting to NS series PT
settings.
Controller
CompoWay
Link
/F Start-Up
Start-Up
Saving Equipment
System Disass'y /
Config. Reass'y
System Controller
Config. Link
Verification Diagnosis