Omron CX-ONE - INTRODUCTION GUIDE 1 Introduction Manual page 25

Starting CX-
Design
Programmer
Click
(Simulator connection button)
Click [OK]
Click [OK]
CX-Simulator debug
console is starts
Starting Switch Box Utility
Select [Tools] >
[SwitchBox Utility]
Run PLC
Setting
Creating Unit
CPU Bus
Configuration
Units/SIOU
Offline Debug
Offline Debug
This section describes how to debug a program using CX-Simulator, a ladder simulation tool,
without the PLC.
Additionally, Switch Box Utility is used as a virtual input tool.
Screen when online
Switch Box Utility
It is useful not only for virtual input by simulator but also for debugging
while checking the PLC's wiring or setting the DM and other initial values.
Checking I/O
Programming
Assignment
Program transfer starts.
Saving
Offline Debug
a Project