System Configuration Verification - Omron CX-ONE - INTRODUCTION GUIDE 1 Introduction Manual

各種PLC
PLC Network
ネットワーク PLC
Start-Up
Start-Up
の立ち上げ
Select [Connect]
Select [Compare]
Click [Close]
Click [OK]
DeviceNet NT Link
Start-Up Start-Up

System Configuration Verification (1)

System Configuration Verification (1)
Confirm that the System has the same wiring and settings as before disassembly.
Confirm that the System has the same wiring and settings as before disassembly.
⇒ CX-Integrator verification is complete.
⇒ CX-Integrator verification is complete.
(1) Connect online to a PLC on a network.
The online connection information window is displayed.
(2) Verify the DeviceNet network configuration.
Connect to a target DeviceNet from the workspace and verify the network Structure.
(3) Any error found in the configuration verification will be displayed in the verification result
dialog box.
(4) After solving the error, verify the configuration again.
Controller
CompoWay
Link
/F Start-Up
Start-Up
A message is displayed indicating
A message is displayed indicating
verification matching and now it can
verification matching and now it can
be confirmed that the configuration is
be confirmed that the configuration is
the same as that before disassembly.
the same as that before disassembly.
Saving Equipment
System Disass'y /
Config. Reass'y
All communications Units and ports
All communications Units and ports
of a connected PLC are
of a connected PLC are
automatically displayed in the online
automatically displayed in the online
connection information window.
connection information window.
If you find a Slave that is not on
If you find a Slave that is not on
the network, you may have
the network, you may have
incorrect wiring in the network.
incorrect wiring in the network.
System Controller
Config. Link
Verification Diagnosis