Chapter 2 Example Of Plc System Construction By Cx-One; Workflow In This Chapter - Omron CX-ONE - INTRODUCTION GUIDE 1 Introduction Manual

Example of PLC System Construction by CX-One
Example of PLC System Construction by CX-One

Workflow in This Chapter

Workflow in This Chapter
This chapter describes an example of PLC System construction from design, online debugging on the actual
machine, and start-up/adjustment on-site as shown below.
CX-Programmer is used for ladder program creation and CPU Bus Units and Special I/O Units (SIOU) setting,
while CX-Designer is used for indicator screen generation. Also, a program simulation Support Software CX-
Simulator is used as a debugging example.
Starting CX-
Programmer
Reading
Project
System Configuration
System Configuration
CX-One
Connection Cable
CS1W-CN226(2m)
PLC1
CJ Series PLC CJ1M
CJ1W-ID211
4 ~ 20mA
Connection Cable
XW2Z-200T(2m)
NS Series PT
NS8-TV00B-V1
System Version 6.0 or later
Setting
Creating Unit
CPU Bus
Configuration
Units/SIOU
Design Online Debug of the Machine
Design Online Debug of the Machine
Online
Transferring
Connection
to PLC
CJ1W-AD081-V1
CJ1W-OC211
Unit No.= 21
CJ1W-NCF71
(CJ1W-MCH71)
Unit No.= 2Hex
CJ1W-DRM21
Unit No.= 0Hex
Node Address= 01
CJ1W-SCU41-V1
Unit No.= 3Hex
CJ1W-CLK21-V1
Unit No.= 1Hex
Node Address= 01
Termination Resistance
Setting= ON
Sensor
Servo Driver
R88D-WN01L-ML2
Checking I/O
Programming
Assignment
Program
to Machine Debug
Unit Name
Power Unit
CPU Unit
DC Input Unit
Transistor Output Unit
Analog Input Unit
Position Control Unit
Motion Control Unit
DeviceNet Master Unit
ControllerLink Unit
Serial Communications
Unit
Servo Driver
NS Series PT
Below is an example of a System that has CJ1M CPU
Unit with basic input/output Unit as well as analog input
Unit and NCF Unit to perform the following functions:
• 4~20mA input from a sensor
• Configure a servo driver connected to the NFC Unit.
Saving
Offline Debug
Project
Start-Up/Adjustment On-Site
Start-Up/Adjustment On-Site
Unit
Program
Parameter
Modification
Change
Model Specifications
CJ1W-PA202
CJ1M-CPU13 640 points, 20K steps
CJ1W-ID211
CJ1W-OC211
4 analog inputs (Each point
CJ1W-AD081-V1 selectable from 1~5V, 0~5V,
0~10V, -10~10V, 4~20mA)
CJ1W-NCF71 Maximum control: 16 axis
CJ1W-MCH71
Maximum control: 30 axis
CJ1W-DRM21
CJ1W-CLK21
CJ1W-SCU41-V1
R88D-WN01L-ML2
NS8-TV00B-V1 8 inches TFT