Omron CX-ONE - INTRODUCTION GUIDE 1 Introduction Manual page 42

PLC Network
PLC
Start-Up
Start-Up
Move the cursor on the
PLC and right-click
Select [Error Log]
DeviceNet NT Link
Start-Up Start-Up
Checking PLC Error
Checking PLC Error
(1) Remove the cause of the PLC error, then make it available to run.
(2) Check the PLC error.
Examples of IO settings error and CPU Bus Units and Special I/O Units number overlap error
are shown below.
(3) Solve the cause of error.
You must solve the problem through the following procedure:
You must solve the problem through the following procedure:
- Set the PLC to PROGRAM mode (in which you can change settings).
- Set the PLC to PROGRAM mode (in which you can change settings).
- Change the rotary switch of the CPU Bus Units and Special I/O Units (make sure
- Change the rotary switch of the CPU Bus Units and Special I/O Units (make sure
that it does not overlap).
that it does not overlap).
- Create the I/O Table.
- Create the I/O Table.
• Set the PLC to PROGRAM mode.
From step (1) above, select [Mode Setting] then [Program] mode, and click the [Set] button.
Controller
CompoWay
Link
/F Start-Up
Start-Up
Saving Equipment
System Disass'y /
Config. Reass'y
You can check an error in a CPU
You can check an error in a CPU
Unit and error history.
Unit and error history.
(You can use the same function in
(You can use the same function in
the error history of CX-Programmer's
the error history of CX-Programmer's
online screen)
online screen)
System Controller
Config. Link
Verification Diagnosis
Click [Yes].