W-Series Servo Drive (R88D-Wn@-Ml2 With Built-In Mechatrolink-Ii Communications) - Omron CJ1W-NC271 - 12-2009 Operation Manual

Servo Parameter Area
4-5-4 W-series Servo Drive (R88D-WN@-ML2 with Built-in
MECHATROLINK-II Communications)
Note
Function Selection Parameters
Param- Parame- Param-
eter No. ter name eter
size
Pn000 Function 2
selection
basic
switches
The Servo Parameters listed here can be used when the Position Control Unit
is used with a W-series Servo Drive with Built-in MECHATROLINK-II Commu-
nications (R88D-WN@-ML2).
For further details on each of the parameters, refer to the user's manual for W-
series Servo Drives.
The timing for Servo Parameters to be enabled are classified into the following
two types.
Online (online parameter): Changed settings are enabled immediately after
Offline (offline parameters): Changed settings are enabled when the Servo
The Details column indicates whether the following conditions apply to the
corresponding parameter.
• Online parameters that can be changed when the axis is stopped (Busy
Flag = 0) only.
• Parameters with standard set values when using MECHATROLINK are
indicated in the Details column as "standard" with the set value. The stan-
dard settings are basic settings required when using the Position Control
Unit. This manual describes operations assuming standard settings are
being used.
For details on fixed and standard settings, refer to 6-4 Standard Settings for
Servo Drives Using MECHATROLINK.
Make sure that the equipment will not be adversely affected before changing
the Servo Parameters (WRITE SERVO PARAMETER, SAVE SERVO
PARAMETER). Refer to the Servo Drive's user's manual and always check
the effect of changing the settings before changing the Servo Parameters.
Contents
Digit Name Set-
No. ting
0 Reverse rota- 0
tion
1
2 to 3
1 Not used. 0
2 Unit No. setting 0 to F
3 Not used. 0
Servo Parameters have been written.
Drive power is cycled or DEVICE SETUP is exe-
cuted.
Default
setting
Explanation
CCW direction is 0
taken for positive
command
CW direction is
taken for positive
command
Not used.
(Do not change the 0
setting.)
Servo Drive com- 0
munications unit
number setting
(necessary for mul-
tiple Servo Drive
connections when
using personal
computer monitor-
ing software)
(Do not change the 0
setting.)
Section 4-5
Unit Setting Enable Details
range setting
--- --- Offline ---
--- --- --- ---
--- --- Offline ---
--- --- --- ---
151