Table of Contents
Advertisement
Parts and their functions
Camera unit
6
9
Rear panel
10
SERVICE
LAN
LINK
ACT
1 - AUDIO INPUT - 2
12 V
IN
16
17
Bottom panel
7
22
11
12
13 14
15
SFP+
12G SDI OUT
USB3.0 HOST
3G SDI OUT
G/L IN
RS-422
1
2/PM
SIGNAL
GND
18
19
20
21
1.
Mount bracket for installation surface (supplied
accessory)
Mount this bracket onto the installation surface, and then attach the
camera main unit to the bracket.
1
2.
Drop‑prevention wire
This wire is screwed down to the bottom panel of the camera main
unit. Loop the circle part of the wire around the hook of the mount
bracket.
3.
Status display lamp
This lights in the following way depending on the status of the unit.
2
Orange
Light up
Blink twice
3
Blinking
4
slowly
Blink three
times
rapidly
5
Green
Light up
6
Blink twice
7
Blinking
rapidly
Red
Light up
Blinking
slowly
Blinking
rapidly
8
4.
Ventilation holes
Blocking the ventilation holes may cause a malfunction. Make sure
there is sufficient space around the ventilation holes.
5.
Tilt head
This rotates in the right and left direction.
6.
Wireless remote control signal light‑sensing area
The light-sensing area is provided in three places, on the front panel
of the camera pedestal and at the top of the rear panel.
7.
Hole for securing the camera pedestal
This hole is provided in the bottom panel of the camera pedestal.
8.
Camera head
This rotates in the up and down direction.
9.
Tally lamp
These turn on/turn off with control signals only when the tally lamp
setting is "ON". The tally lamps light in three different colors; red,
green, and yellow.
10.
LAN connector for IP control <LAN LINK/ACT>
This LAN connector (RJ-45) is connected when exercising IP control
over the unit from an external device. Use a LAN cable (category 5e
or above, max STP 100 m (328 ft)) for connection.
18
When the standby status is established
When a signal not matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
Firmware being updated (STEP 1: files being
transferred)
When the Identify function (a function that makes
the status display lamp of a specified camera
blink) of EasyIP Setup Tool Plus operates
When the power is on
When a signal matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
When the initialization process is complete
When trouble has occurred in the unit
Firmware being updated (STEP 2: data being
written)
When a PoE++ software authentication error has
occurred
Advertisement
Table of Contents
