Panasonic HEVC Advance AW-UE160WP Operating Instructions Manual page 132

Web screen configurations (continued)
Encryption [Off, AES-128, AES-256]
Sets whether to encrypt the transmitted IP image. (10 to
24 characters)
Off Transmits unencrypted IP images.
AES-128 Encrypts IP images in AES-128 before transmitting.
AES-256 Encrypts IP images in AES-256 before transmitting.
Factory settings: Off
• The following characters can be displayed.
Numeric characters 0123456789
Alphabetical ABCDEFGHIJKLMNOPQRSTUVWXYZ
characters abcdefghijklmnopqrstuvwxyz
(upper and lower
cases)
Symbols _-
Passphrase
Sets the phrase used for decoding the encrypted IP images.
Streaming format
Makes settings for H.264 or H.265 images for use in SRT
transmission.
The setting is confirmed with the [Set] button.
Refer to the explanation for [H.264] (→ page 127) or [H.265]
(→ page 129) for information about [Profile type], [Image capture
size], [CBR/VBR], [Frame rate] and [Max bit rate(per client)].
<NOTE>
• [Streaming format] settings cannot be changed during SRT
transmissions.
• When [IP(UDP)] of [Tracking Data Output] is set to [On], video
transmission via IP may be delayed or the video may suffer frame
loss. (→ page 165)
We recommend [IP(UDP)] of [Tracking Data Output] is set to [Off]
during SRT transmission.
• When the frame frequency is 24/23.98Hz, you cannot set to the
SRT(H.264), SRT(H.264 UHD), SRT(H.265), or SRT(H.265 UHD)
modes.
z MPEG2‑TS over UDP
Make settings for MPEG2-TS over UDP transmission.
<NOTE>
• In order to receive the images being transmitted by the camera, enter
the following URL in the application or service.
- For Unicast
udp://@[unicast ipaddress]:[unicast port]
- For Multicast
udp://@[multicast ipaddress]:[multicast port]
Transmission type [Unicast, Multicast]
Sets the transmission type for MPEG2-TS over UDP transmission as
either [Unicast] or [Multicast].
Factory settings: Unicast
Unicast address(IPv4)
Sets the Unicast address used for MPEG2-TS over UDP
transmission.
Specify this IP address on the receiving application or service.
Factory settings: 192.168.0.3
Unicast Port [1024 to 50000]
Sets the Unicast port number used for MPEG2-TS over UDP
transmission.
Specify this port number on the receiving application or service.
Factory settings: 7002
Multicast address(IPv4)
Sets the Multicast address used for MPEG2-TS over UDP
transmission.
Specify this IP address on the receiving application or service.
Factory settings: 239.192.0.20
Multicast Port [1024 to 50000]
Sets the Multicast port number used for MPEG2-TS over UDP
transmission.
Specify this port number on the receiving application or service.
Factory settings: 32004
Multicast TTL/HOPLimit
The same as [H.264] [Multicast TTL/HOPLimit] (→ page 129).
Push UDP [Enable, Disable]
When [Push UDP] has been set to [Enable], MPEG2-TS over UDP
transmission starts automatically when the camera is started.
Factory settings: Enable
132