Parts And Their Functions; Camera Unit - Panasonic AW-UE80WP Operating Instructions Manual

Parts and their functions

Camera unit

6
9
Rear panel
10
G/L IN
RS-422
3G SDI OUT
IR ID SERVICE
16 17 18
Bottom panel
7
21
11 12 6 13 14 15
DC IN 12V
AUDIO IN
LAN
LINK ACT
19 20
1.
Mount bracket for installation surface (supplied
accessory)
Mount this bracket onto the installation surface, and then attach the
camera main unit to the bracket.
1
2.
Drop‑prevention wire
This wire is screwed down to the bottom panel of the camera main
unit. Loop the circle part of the wire around the hook of the mount
bracket.
3. Status display lamp
This lights in the following way depending on the status of the unit.
2
Orange Light up
Blink twice
3
Green Light up
Blink twice
4
Blinking
5
rapidly
Red Light up
Blinking
slowly
7
Blinking
rapidly
4.
Ventilation holes
Blocking the ventilation holes may cause a malfunction. Make sure
there is sufficient space around the ventilation holes.
5.
Pan head
This rotates in the right and left direction.
8
6.
Wireless remote control signal light‑sensing area
There are three light-sensing areas on the front and rear panels of the
camera pedestal.
7.
Hole for securing the camera pedestal
This hole is provided in the bottom panel of the camera pedestal.
8.
Camera head
This rotates in the up and down direction.
9.
Tally lamp
This comes on or goes off in response to the control from the
controller but only when "On" has been selected as the tally lamp use
setting. The tally lamp is red or green.
Red Light up
Blink once
Blink twice
Blink three
times
Green Light up
16
When the standby status is established
When a signal not matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
When the power is on
When a signal matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
When the initialization process is complete
When trouble has occurred in the unit
Firmware being updated
When a PoE++ software authentication error has
occurred
When receiving a red tally signal
When a Pan/Tilt limit is set
When the Pan/Tilt limit is canceled
When start up of this unit is complete
When receiving a green tally signal