Panasonic HEVC Advance AW-UE160WP Operating Instructions Manual page 134

4k integrated camera
Hide thumbs Also See for HEVC Advance AW-UE160WP:
Table of Contents

Advertisement

Web screen configurations (continued)
Subnet(IPv4)
Enter the subnet mask.
Factory settings: 225.255.255.255
<NOTE>
• [Address (IPv4)] and [Subnet (IPv4)] clarify the multicast address
ranges randomly set during multicast transmissions.
• When [Address (IPv4)] is set to [239.255.0.0] and [Subnet (IPv4)]
is set to [255.255.0.0], the selection is made randomly in the range
between [239.255.0.0] and [239.255.255.255].
• To use the IP address set in [Address (IPv4)], set [Subnet (IPv4)]
to [255.255.255.255].
TTL/HOP Limit
The same as the [H.264] [Multicast TTL/HOPLimit] (→ page 129).
Group [Enable, Disable]
Sets whether to use the grouping function when performing NDI
transmission.
Factory settings: Disable
Name
Sets the group name for use when the grouping function is used.
Maximum number of
1 to 32 characters
characters
Characters that can be
Alphanumeric characters
entered
Use discovery server
Sets whether to use the discovery server when performing NDI
transmission.
Server address(IPv4)
Sets the IPv4 address of the server when using the discovery
server.
Streaming format
Make settings for H.264 images used for NDI|HX V2 transmission.
Confirm the settings with the [Set] button.
Refer to the explanation of [H.264] (→ page 127) for information 
about [Image capture size], [Frame rate], [Max bit rate(per client)] and
[CBR/VBR].
z High bandwidth NDI
Make NDI transmission settings.
The setting is confirmed with the [Set] button.
High bandwidth NDI
Format
Displays the resolution of NDI images.
<NOTE>
• For the resolution set to Format, confirm the output conditions for
each video format (→ page 21).
Source name
Set the device name displayed when this unit is detected by software
applications and hardware compatible with NDI.
Factory settings: NDI Device [serial number of this unit]
Protocol [TCP, UDP, RUDP]
Sets the format of unicast transmission to be used.
Factory settings: RUDP
Multicast Transmit [On, Off]
Sets whether to perform multicast transmission of images for the
software applications and hardware compatible with NDI.
Factory settings: Off
Address(IPv4)
[IPv4 : 224.0.0.0 to 239.255.255.255]
Enter the multicast IP address.
Images and audio will be sent to the specified IP address.
Factory settings: 239.192.0.30
<NOTE>
• Verify usable multicast IP addresses before entering this setting.
134

Advertisement

Table of Contents
loading

Table of Contents