Table of Contents
Advertisement
Web screen configurations (continued)
z RTSP
This performs settings related to the RTSP function. The RTSP function
sets the RTSP transmission port and RTSP request URL used during IP
image transmission.
The setting is confirmed with the [Set] button.
RTSP port [1 to 65535]
Sets the RTSP reception port no.
The following port numbers are used by the unit so they cannot be
used.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 546,
547, 995, 5960 to 5985, 7960 to 8060, 10669, 10670, 11900, 59000
to 61000
Factory settings: 554
RTSP request URL
Sets up the URL for RTSP when making IP image transmission
demands to this unit.
RTSP request URL H.264(1)
RTSP request URL H.264(2)
RTSP request URL H.264(3)
RTSP request URL H.265(1)
RTSP request URL H.265(2)
Factory settings:
RTSP request URL H.264(1)
RTSP request URL H.264(2)
RTSP request URL H.264(3)
RTSP request URL H.265(1)
RTSP request URL H.265(2)
• Up to 255 characters can be entered.
• The following characters can be displayed.
Numeric characters
0123456789
Alphabetical
ABCDEFGHIJKLMNOPQRSTUVWXYZ
characters (upper and
abcdefghijklmnopqrstuvwxyz
lower cases)
Symbols
/ - _
<NOTE>
• RTSP request URL cannot have the same URL.
RTSP URL for H.264(1) image
transmission
RTSP URL for H.264(2) image
transmission
RTSP URL for H.264(3) image
transmission
RTSP URL for H.265(1) image
transmission
RTSP URL for H.265(2) image
transmission
MediaInput/h264/stream_1
MediaInput/h264/stream_2
MediaInput/h264/stream_3
MediaInput/h265/stream_1
MediaInput/h265/stream_2
z SNMP
Make SNMP functionality related settings. You can check the status of
the unit by using the SNMP manager to connect.
The setting is confirmed with the [Set] button.
SNMP [On, Off]
Sets whether to use the SNMP function.
Factory settings: Off
User name
Sets the user name used for user authentication.
You need to specify the same user name that you set here in the
SNMPv3 manager.
Maximum number
0 to 32 characters
of characters
Characters that
Double-byte
cannot be entered
Authentication
Sets the algorithm used for user authentication.
MD5
MD5 is used as the algorithm for user authentication.
SHA1
SHA1 is used as the algorithm for user authentication.
Factory settings: SHA1
Encryption method
Sets the encryption method used for communications.
DES is used as the encrypted communication method for
DES
SNMPv3.
AES is used as the encrypted communication method for
AES
SNMPv3.
Factory settings: AES
Password
Sets the password used for user authentication.
You need to specify the same password that you specified here in the
SNMPv3 manager.
When [Authentication] is set to [MD5]:
Maximum number
8 to 16 characters
of characters
When [Authentication] is set to [SHA1]:
8 to 20 characters
Characters that
Double-byte
cannot be entered
175
Advertisement
Table of Contents
