Table of Contents
Advertisement
Web screen configurations (continued)
Network setup screen [Network]
Configure network settings in the Network setup screen [Network].
The Network setup screen [Network] consists of [Network] and
[Advanced].
„
Network setup screen [Network]
Click the [Network] of the Network setup screen [Network].
Make the settings on the pages for the items.
The following information is required to configure network settings.
Consult your network administrator or Internet service provider.
• IP address
• Subnet mask
• Default gateway (when using a gateway server or router)
• HTTP port
• DNS primary and secondary server addresses (when using DNS),
domain
<NOTE>
• If the subnet of the IP address set for the LAN, SFP+, and USB is
duplicated, the network connectivity of the unit cannot be guaranteed,
so take note of the IP addresses set manually and the IP addresses
allocated by the DHCP.
• When connecting to IP addresses that have differing subnets, set so
the metric of the interface to be used is the minimum value.
For example, when connecting to IP addresses where the domain
name has been resolved, set the metric of the interface to be used to
the minimum value.
• When multicast transmission is to be used, set the metric of the
interface to be used to the minimum value.
• Multicast transmissions other than with the Media over IP function
using the SFP+ interface are not possible.
• If the same subnet was set and you cannot access this unit, set an IP
address with a different subnet with the EasyIP Setup tool, then revise
the settings again from the web page.
• If the metric values are set to the same values for each of the
interfaces, the network connectivity of the unit cannot be guaranteed,
so take note of the IP addresses set manually and the IP addresses
allocated by the DHCP.
z LAN
IPv4 network
DHCP [On, Off]
Select the method in which the IP address is configured.
Factory settings: Off
<NOTE>
• When [DHCP] is set to [On], AW-RP150/AW-RP60's automatic
configuration of IP address (AUTO IP) cannot be used.
IP address(IPv4)
Input the unit's IP address here when the DHCP function is not
going to be used. Input an address that will not duplicate an existing
IP address which has been set for a personal computer or another
network camera.
Factory settings: 192.168.0.10
<NOTE>
• Multiple IP addresses cannot be used even when the DHCP
function is used. For details on the DHCP server settings, consult
your network administrator.
Subnet mask
Input the unit's subnet mask here if the DHCP function is not going to
be used.
Factory settings: 255.255.255.0
Default gateway
Input the unit's default gateway if the DHCP function is not going to
be used.
Factory settings: 192.168.0.1
<NOTE>
• Multiple IP addresses cannot be used for the default gateway even
when the DHCP function is used.
For details on the DHCP server settings, consult your network
administrator.
169
Advertisement
Table of Contents
