Parts And Their Functions; Camera Unit - Panasonic AW-HE145WP Operating Instructions Manual

Parts and their functions

Camera unit

5
8
Rear panel
9 10
LAN
LINK ACT
RS-422
12 V IN
IR ID
AUDIO IN
15 16 18
17
Bottom panel
6
20
11 12
13 14
SERVICE
3G SDI OUT G/L IN
19
1.
Mount bracket for installation surface (supplied
accessory)
Mount this bracket onto the installation surface, and then attach the
camera main unit to the bracket.
2.
Drop‑prevention wire
This wire is screwed down to the bottom panel of the camera main
1
unit. Loop the circle part of the wire around the hook of the mount
bracket.
3.
Status display lamp
This lights in the following way depending on the status of the unit.
Orange Light up
2
Blink twice
3
Green Light up
Blink twice
Blinking
rapidly
4
Red Light up
5
Blinking
slowly
6
Blinking
rapidly
4. Pan head
This rotates in the right and left direction.
5.
7 Wireless remote control signal light‑sensing area
The light-sensing area is provided in three places, on the front panel
of the camera pedestal and at the top of the rear panel.
6.
Hole for securing the camera pedestal
This hole is provided in the bottom panel of the camera pedestal.
7.
Camera head
This rotates in the up and down direction.
8. Tally lamp
This comes on or goes off in response to the control from the
controller but only when "On" has been selected as the tally lamp use
setting. The tally lamp is red or green.
9.
LAN connector for IP control <LAN LINK/ACT>
This LAN connector (RJ-45) is connected when exercising IP control
over the unit from an external device. Use a LAN cable
or better, STP, maximum 100 m (328 ft)) for connection.
*
1
Use of an STP (shielded twisted pair) cable is recommended.
15
When the standby status is established
When a signal not matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
When the power is on
When a signal matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is on
When the initialization process is complete
When trouble has occurred in the unit
Firmware being updated
When a PoE++ software authentication error has
occurred
*
(category 5e
1