Table of Contents
Advertisement
Camera menu items (continued)
WHITE SHADING
Perform white shading correction.
Make horizontal and vertical adjustments to the sawtooth waveforms
and parabola waveforms of each of the RGB channels.
CORRECT [OFF, ON]
Set ON/OFF for the white shading (sawtooth waveforms or parabola
waveforms) correction.
W H SAW R [–100 to 0 to +100]
Adjust the gain of the white shading for the Rch horizontally using the
sawtooth waveform.
W H SAW G [–100 to 0 to +100]
Adjust the gain of the white shading for the Gch horizontally using the
sawtooth waveform.
W H SAW B [–100 to 0 to +100]
Adjust the gain of the white shading for the Bch horizontally using the
sawtooth waveform.
W H PARA R [–100 to 0 to +100]
Adjust the gain of the white shading for the Rch horizontally using the
parabola waveform.
W H PARA G [–100 to 0 to +100]
Adjust the gain of the white shading for the Gch horizontally using the
parabola waveform.
W H PARA B [–100 to 0 to +100]
Adjust the gain of the white shading for the Bch horizontally using the
parabola waveform.
W V SAW R [–100 to 0 to +100]
Adjust the gain of the white shading for the Rch vertically using the
sawtooth waveform.
W V SAW G [–100 to 0 to +100]
Adjust the gain of the white shading for the Gch vertically using the
sawtooth waveform.
W V SAW B [–100 to 0 to +100]
Adjust the gain of the white shading for the Bch vertically using the
sawtooth waveform.
W V PARA R [–100 to 0 to +100]
Adjust the gain of the white shading for the Rch vertically using the
parabola waveform.
W V PARA G [–100 to 0 to +100]
Adjust the gain of the white shading for the Gch vertically using the
parabola waveform.
W V PARA B [–100 to 0 to +100]
Adjust the gain of the white shading for the Bch vertically using the
parabola waveform.
WIRELESS CONTROL
WIRELESS CONTROL [ENABLE, DISABLE]
[ENABLE] or [DISABLE] is set here for operations conducted from the
wireless remote control.
WIRELESS ID [CAM1, CAM2, CAM3, CAM4]
Set the remote control ID (CAM1 to CAM4).
The [CAM1] to [CAM4] in this setting correspond to the CAMERA <1>
to <4> buttons on the wireless remote control.
<NOTE>
• When the power is turned on from Standby with the wireless remote
control, operations from the wireless remote control are possible
irrespective of this setting value.
• This item is not reflected immediately when the setting is changed.
It is reflected when the unit is set to Standby mode, and then the
power is turned ON with any external device other than the wireless
remote control.
• This setting is not reflected when the power is turned ON with this
item set to [DISABLE]. It is reflected when the unit is set to Standby
mode, and then the power is turned ON with any external device
other than the wireless remote control.
STATUS LAMP
STATUS LAMP [ENABLE, DISABLE]
[DISABLE] or [ENABLE] is set here for the status display lamp.
When you want the status display lamp to stay off while this unit is in
operation, set to [DISABLE].
<NOTE>
• Even when set to [DISABLE], the status display lamp may light
up when this unit is starting up, updating firmware, or trouble is
occurring.
83
Advertisement
Table of Contents
