Table of Contents
Advertisement
Web screen configurations (continued)
LEVEL GAUGE [Off, On]
When [On], the status of the incline (horizontally, to the left or right or
front and back) of the unit installation is displayed as OSD in the top
left of the screen.
Factory settings: Off
(Example)
L↑ +3.2/-3.2↓R
F↓ -1.8/+1.8↑F
In the case of the display above, the unit is installed at an inclination
of 3.2° upward to the left and 1.8° upward in to the front.
The maximum incline is ±9.9°, and when there is an incline of 10° or
greater, the display shows "±9.9".
<NOTE>
• This is displayed only through the SDI, HDMI, SMPTE ST2110, and
High bandwidth NDI outputs. It is not displayed with IP transmission
(H.264/H.265/M-JPEG).
• The LEVEL GAUGE value is not updated during PAN/TILT
operation.
„
Lens setting screen [Lens]
The setting is confirmed with the [Set] button.
Focus Mode [Manual, Auto]
Select auto or manual mode for the focus adjustment function.
Manual
Adjust focus manually.
Auto
Always adjust focus automatically.
Factory settings: Auto
AF Sensitivity [NORMAL, STABLE]
Select the conformability mode for auto focusing function.
NORMAL
Focusing is with a standard conformability.
STABLE
Focusing is with a priority placed on stability.
Factory settings: NORMAL
Zoom Mode [Opt.Zoom, i.Zoom, D.Zoom]
Set the maximum magnification rate for zoom.
Opt.Zoom
Use only optical zoom.
Optical zoom up to 20× is possible.
i.Zoom
Enable the i.Zoom function.
When this function is enabled, digital zoom is used while
reducing image degradation.
When [Basic Config] – [Format] is 2160/59.94p,
2160/29.97p, 2160/50p, 2160/25p, 2160/24p,
2160/23.98p
Up to 28× zoom is possible combining optical zoom and
digital zoom.
• When [Basic Config] – [Format] is other than one of
these, up to 32× zoom is possible combining optical
zoom and digital zoom.
D.Zoom
Enable the digital zoom function.
Higher digital zoom magnifications will result in coarser
images.
Factory settings: Opt.Zoom
Max Digital Zoom
[×2, ×3, ×4, ×5, ×6, ×7, ×8, ×9, ×10]
Set the maximum digital zoom magnification.
This is only enabled when [Zoom Mode] is set to [D.Zoom].
Factory settings: ×10
<NOTE>
• Higher digital zoom magnifications will result in coarser images.
157
Advertisement
Table of Contents
