Network Setup Screen - Panasonic AW-HE130W Operating Instructions Manual

Web screen configurations (continued)
Priority stream screen
„
Click the Priority stream tab of User mng. screen. (→page@@, page
@@)
Selected on this screen are the settings for the priority stream which
enables the images to be sent with no reduction in image quality
or image refresh speed even when a multiple number of users are
accessing the unit at the same time.
z Priority Stream
Activation [On, Off]
Whether to use priority stream transmission is set here using "On" or
"Off".
Setting value:
On Use priority stream transmission.
Off Do not use priority stream transmission.
Factory settings: Off
<NOTE>
• When [Activation] is set to [On], the number of users that can
access the unit may be restricted.
Destination IP address (1)
The IP address of the first send destination is input here.
Destination IP address (2)
The IP address of the second send destination is input here.
Stream Type
Select the stream type
Setting value:
JPEG(1) JPEG(1) images are sent.
JPEG(2) JPEG(2) images are sent.
JPEG(3) JPEG(3) images are sent.
H.264(1) images are sent.
H.264(1)
H.264(2) images are sent.
H.264(2)
H.264(3) images are sent.
H.264(3)
H.264(4) images are sent.
H.264(4)
Factory settings: JPEG(1)
<NOTE>
• When [Transmission priority] (→ page @@) is set to [Best effort] for
[H.264], transmissions will occur at a variable bit rate between the
maximum and minimum bit rate depending on the connection status
of the other users.
Refresh interval
Select the frame rate.
This is enabled only when [Stream Type] is set to [JPEG(1)],
[JPEG(2)], or [JPEG(3)].
Setting value:
For 60Hz:
1fp / 2fps / 3fps / 5fps / 6fps
For 50Hz:
1fps/2fps/5fps/10fps /12.5fps
*
Factory settings: 1 fps
*
1
When [H.264 transmission] is set to [On], the frame rate may be
slower than the specified value in some cases.
/ 10fps / 15fps 1 / 30fps 1
* * * *
/25fps
1 1
* *

Network setup screen

Configure network settings in the Network setup screen.
The Network setup screen consists of the two tabs of "Network" and
"Advanced".
Network setup screen
„
Click the "Network" tab of the Network setup screen. (→page@@, page
@@)
The following information is required to configure network settings.
Consult your network administrator or Internet service provider.
• IP address
• Subnet mask
• Default gateway (when using a gateway server or router)
• HTTP port
• DNS primary and secondary server addresses (when using DNS)
89