Diagnostic - ZyXEL Communications GS1920v2 Series User Manual

Table 244 MAINTENANCE > Configuration > Configure Clone (continued)
LABEL
PORT
SWITCHING
NETWORKING
SECURITY
Apply
Cancel

67.13 Diagnostic

Click MAINTENANCE > Diagnostic in the navigation panel to open this screen. Use this screen to ping IP
addresses, run a traceroute, perform port tests or show the Switch's location between devices.
Figure 320 MAINTENANCE > Diagnostic
Chapter 67 MAINTENANCE
DESCRIPTION
Select which port features (you configured in the PORT menus) should be copied to the
destination ports. Otherwise, select the PORT check box in the table heading row to select all
features for a category.
Select which switching features (you configured in the SWITCHING menus) should be copied to
the destination ports. Otherwise, select the SWITCHING check box in the table heading row to
select all features for a category.
Select the networking feature (you configured in the NETWORKING menus) to be copied to the
destination ports. Otherwise, select the NETWORKING check box in the table heading row to
select all features for a category.
Select which security features (you configured in the SECURITY menus) should be copied to the
destination ports. Otherwise, select the SECURITY check box in the table heading row to select all
features for a category.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS1920v2 Series User's Guide
438