Ipv6 Neighbor Setup - ZyXEL Communications MES3500-24S User Manual

Table 23 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Discovery Setup (continued)
LABEL
DAD Attempts
NS Interval
Reachable Time

8.8.8 IPv6 Neighbor Setup

Use this screen to create a static IPv6 neighbor entry in the Switch's IPv6 neighbor table to store the
neighbor information permanently. Click the link next to IPv6 Neighbor Setup in the IPv6 Configuration
screen to display the screen as shown next.
Figure 42 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
The following table describes the labels in this screen.
Table 24 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
LABEL
Interface Type
Interface ID
Neighbor Address
MAC
Chapter 8 Basic Setting
DESCRIPTION
This field displays the number of consecutive neighbor solicitations the Switch sends for this
interface.
This field displays the time interval (in milliseconds) at which neighbor solicitations are re-
sent for this interface.
This field displays how long (in milliseconds) a neighbor is considered reachable for this
interface.
DESCRIPTION
Select the type of IPv6 interface for which you want to configure. The Switch supports the
VLAN interface type for IPv6 at the time of writing.
Specify a unique identification number (from 1 to 4094) for the interface.
Note: A static IPv6 neighbor entry displays in the Management > Neighbor Table
screen only when the interface ID is also created in the Basic Setup >
Interface Setup screen.
Note: To have IPv6 function properly, you should configure a static VLAN with
the same ID number in the Advanced Setup > VLAN screens.
Specify the IPv6 address of the neighboring device which can be reached through the
interface.
Specify the MAC address of the neighboring device which can be reached through the
interface.
MES3500-24S/MGS3520 Series User's Guide
96