Step 2: Install The Mounting Hardware In A Four-Post Rack Or Cabinet Or An Open-Frame Rack - Juniper MX480 Quick Manual

MX480 3D Universal Edge Router Quick Start
Step 2: Install the Mounting Hardware in a Four-Post Rack or Cabinet or an Open-Frame
Rack
6
To install the mounting shelf on the front rails of a four-post rack or cabinet, or the rails
of an open-frame rack:
If needed, install cage nuts in the holes specified in
1.
On the back of each rack rail, partially insert a mounting screw into the lowest hole
2.
specified in Table 1 on page
Install the mounting shelf on the back of the rack rails. Rest the bottom slot of each
3.
flange on a mounting screw.
Partially insert screws into the open holes in each flange of the mounting shelf (see
4.
Figure 2 on page 7 or Figure 3 on page
Tighten all the screws completely.
5.
Table 1: MX480 Mounting Hole Locations
Hole Distance Above U Division
4 2.00 in. (5.1 cm)
3 1.51 in. (3.8 cm)
2 0.88 in. (2.2 cm)
1 0.25 in. (0.6 cm)
Table 1 on page
6.
8).
1.14 U
0.86 U
0.50 U
0.14 U
Copyright © 2015, Juniper Networks, Inc.
6.
Mounting Shelf
X
X
X
X