Table of Contents
Advertisement
8.
Using the pallet jack, position the router in front of the rack or cabinet, centering it in front of the
rack.
NOTE: If you are installing the MX2010 router into a network cabinet, make sure that no
hardware, device, rack, or cabinet component obstructs the 34-U rack space from access
during installation.
9.
Using the pallet jack, lift the chassis approximately 0.75 in. (1.9 cm) above the surface of the
mounting shelf (four-post rack) or bottom opening of the rack (open-frame rack), and position it as
close as possible.
NOTE: Because of the short lift capability of the pallet jack, we recommend that you install
the router on the bottom of the rack.
10. Remove the shipping brackets that are attached to the pallet jack attachment and chassis, and set
them aside.
11. Grasp the handles on the shipping covers and carefully slide the router into the rack (see and
15 on page 27
and
continue sliding the router onto the mounting shelf so that the bottom of the chassis and the
mounting shelf overlap by approximately 2 in. (5.0 cm).
12. With four people pushing on the front-mounting flanges, slide the router until the center-mounting
brackets (open-frame racks) or front-mounting flanges (four-post racks) contact the rack rails. In a
four-post rack, the mounting shelf ensures that the holes in the front-mounting flanges of the
chassis align with the holes in the rack rails.
13. Move the pallet jack away from the rack.
14. Insert twelve mounting screws (six on each side) into the mounting holes to secure the router to the
rack.
15. Visually inspect the alignment of the router. If the router is installed properly in the rack, all the
mounting screws on one side of the rack should be aligned with the mounting screws on the
opposite side, and the router should be level.
Figure 16 on page
28). If you are installing the router into a four-post rack,
26
Figure
Advertisement
Table of Contents
