Table of Contents
Advertisement
Power interposer board
This is a service technician replaceable part only.
Removing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
4. Remove the
PSU
or
PSU
5. Disconnect the cables that are connected to power interposer board (PIB).
NOTE:
Systems shipped since Nov'22 may have a different power distribution board and connectors.
Steps
1. Using a Phillips #2 screwdriver, remove the screws securing the power interposer board to the system.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Lift the PIB away from the system.
Figure 123. Removing the power interposer board
Next steps
Replace the power interposer
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Safety
instructions.
Before working inside your
blank.
board.
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
119
Advertisement
Table of Contents
