Cooling Fan Cage Board; Removing The Cooling Fan Cage Board - Dell EMC PowerEdge R550 Installation And Service Manual

Figure 101. Installing the power interposer board
Next steps
1. Connect the cables to the PIB and route them properly.
2. Install the PSU.
3. Install the air shroud.
4. Follow the procedure listed in

Cooling fan cage board

Removing the cooling fan cage board

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the following components:
a. Air shroud
b. Cooling fan cage assembly
4. Disconnect cables from the fan board.
Steps
1. Using a Phillips #2 screwdriver. remove the screws that secures the fan board to the system.
2. Holding the edges lift the fan board out of the system.
102 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.