Nortel Meridian 1 option 11C Planning And Installation Manual page 360

3DJH#693#RI#699 #&KDSWHU#56#±#&KDQJLQJ#SUH0SURJUDPPHG#GDWD
0RGLI\LQJ#PRGHO#WUXQNV
5HPRYLQJ#PRGHO#WUXQNV
3ULQWLQJ#PRGHO#LQIRUPDWLRQ
886063540543 6WDQGDUG#8133
If you want to modify a trunk, load LD 14 and type in the following
commands on the TTY:
/' 47
REQ CHG
TYPE aaa M "aaa" = the type of trunk that you are
modifying
MODL YYY "YYY" = the model number of the trunk
that you are modifying (between 1 - 127)
To remove a trunk model from the system, load LD 14 and respond to the
prompts as follows:
/' 47
REQ OUT
TYPE XXX M "XXX" = the trunk type of the model that
you are removing (Examples: COT, TIE,
DID, FEX, WAT, etc.)
CUST 0
MODL YYY "YYY" = the model number associated
with the trunk type you are removing
(Valid range is 1-127).
To print information about model trunks, load LD 20 and type in the
following commands on the TTY:
/' 53
REQ PRT
TYPE TTTT M "TTTT" = the trunk type
MODL YYY "YYY" = the model number. If you want to print all of the
models for this trunk type, leave this value blank.
$SULO#5333